First disconnect the negative cable from the battery, then the positive cable from the battery. Then trace to the other end %26amp; disconnect any keepers along the way. Disconnect the other end (probably @ the starter solenoid)How to change positive battery cable on a 99 trans am??
uh....remove old one and put new one on.......How to change positive battery cable on a 99 trans am??
the big hole goes on the battery, and the smaller hole goes on the big bolt on the starter.How to change positive battery cable on a 99 trans am??
On a V8:
1.Remove the battery.
2.Remove the positive cable from the stud on the fuseblock.
- Open the positive cable cap.
- Remove the battery cable to fuseblock stud nut.
- Remove the positive cable from the fuseblock stud.
3.Raise and suitably support the vehicle.
4.Remove the conduit rosebud clips at the cooling fans.
5.Remove the wiring harness ground bolt and RF (Radio Frequency) ground strap and cruise control ground lead at the front rail.
6.Remove the positive cable from the generator.
- Slide the boot down revealing the positive terminal stud.
- Remove the positive cable nut from the generator output stud.
- Remove the positive cable.
7.Remove the positive cable to starter motor nut
8.Remove the positive cable from the starter motor .
9.Remove the positive cable from the harness conduit.
On a V6:
1.Remove the battery.
2.Remove the positive cable from the stud on the fuseblock:
- Open the positive cable cap.
- Remove the positive cable to fuseblock stud nut.
- Remove the positive cable from the fuseblock stud.
3.Remove the positive cable from the rosebud clip at the power steering reservoir.
4.Remove the wiring harness ground bolt and RF (Radio Frequency) ground strap and cruise control ground lead from the front rail.
5.Remove the positive cable from the generator:
- Slide the boot down revealing the positive terminal stud.
- Remove the positive cable nut from the generator input stud.
- Remove the positive cable.
6.Remove the positive cable rosebud clip from the engine lift bracket.
7.Remove the positive cable rosebud clips from the cooling fans.
8.Raise and suitably support the vehicle.
9.Remove the positive/negative cable from the engine mount stud:
- Remove the positive cable RF (Radio Frequency) ground nut (2).
- Remove the harness clamp from the stud.
- Remove the RF (Radio Frequency) ground strap.
10.Remove the starter motor shield.
11.Remove the positive cable from the starter solenoid:
- Remove the positive cable to starter motor nut (1).
- Remove the positive cable from the harness conduit.
Installation procedure: Reverse the removal procedure.
Send me your email address and I can email you the entire procedure.
